These regulators were designed to unsurpassed protection for your offer 2005
Kawasaki Ninja ZX6R 636 in the unfortunate event of a low side or tip over.
Motovation Frame Sliders are designed and manufactured by a company that only
makes Sliders. Each model is tested for drop and slide protection.
They are hard but not brittle and can also absorb a great influence. Sport Riders
around the world, the various models of our products have been tested for theLength have
all because of their thumbs up after experiencing first hand the benefits of Motovation
Sliders.
Please read all instructions before beginning work! These crash pads are designed
special engine mounts to fit your 2005 Kawasaki ZX6R 636 Ninja. This kit
has separate left and right pieces (left and right, sitting) on the bike. It is
strongly recommended that you refer to your service manual before implementing a
Installation. Some panelChange is required on the left side.
Included in this framework Slider Kit (1) 10mmX90mm 1.25 pitch screw (left) (1) 1.25 pitch bolt right () (2) aluminum bushings 10mmX130mm (pressed in control) (2) Plastic Frame Sliders ( shorter, with more left-right)
NOTES:
Left side (Sitting On Bike) Remove the left panel. Remove (see corrected figure) to engine bolt and the nut to be saved. Replace with the supplied left frame slider (Longer aluminum spacer) and 100mm
Bolt
and re-use while the mother. Tighten the frame slider back to the manufacturer's recommended torque. Replace the cover and mark the edge of the panel, the amendment must be. Tape
Cladding with duct tape and Dremel disguise until they approved only the frame
Slider.
Install cover.
Remove your right (Sitting On Bike) (see picture) to correct engine bolt and save the mother. Install the supplied right frame slider (Shorter aluminum spacer) and 130mmBolt
and
Reuse mother. Tighten the frame slider back to the manufacturer's recommended torque.
NOT OVERTIGHTEN.
0 ความคิดเห็น:
แสดงความคิดเห็น